Minibox V3.2 How to config ap+client mode

How to config ap+client mode   1. for now,this mode only suit for lede but not QSDK 2. We need to modify the config manually 3. Here is the two router one is ap the other one is client Step 1 : config the ap router      1. DHCP enable      2. Mode : Access Point… read more »

How to connect PQI20 to the DEV Board

PQI20 QCA9886 as shown in the following figure,It can be connected according to the design of our bottom plate: Note: P is the output ; N is the input . The electrical characteristics of the 100 meter clock of pice are designed according to the differential 100 ohm impedance. The electrical characteristics according to Mini PCIE… read more »

Oolite-Box V1.0 Mini-Pcie Interface Instruction

Oolite-Box V1.0 have two Mini-Pcie interface,but they are different. Mini-Pcie on the left side is LTE Module (USB interface) +WiFi Chip (Mini-Pcie) Mini-Pcie on the right side is LTE Module only (USB interface) we have design a switch (GPIO control) to control LTE Module Power. left Mini-Pcie(Module) use GPIO#2 to control it's power. right Mini-Pcie(Module)… read more »

Oolite V5.1 Hardware User Manual

Development Board ==================================================================================================== Schematic Diagram OOLITEV5_1_DEV_V1_0_2.pdf http://oolite.cn/wp-content/uploads/2018/04/OOLITEV5_1_DEV_V1_0_2.pdf OOLITEV5_1_DEV_V1_0_2.DSN  http://oolite.cn/wp-content/uploads/2018/04/OOLITEV5_1_DEV_V1_0_2.zip PCB OOLITEV5_1_DEV_V2.0.pcb  http://oolite.cn/wp-content/uploads/2018/04/OOLITEV5_1_DEV_V2.0.pcb Notice:    Just for reference,pleace make sure it's right by yourself!

How to compile the MiniBox V3.2 lede firmware

1.download the lede source code  2.git pull ,update the source code  3.try the reset the "git log" to bf4aa52dbf9f4ecb4e48f815e30357976605a12a   git reset –hard bf4aa52dbf9f4ecb4e48f815e30357976605a12a 3.update the package ./scripts/feeds update -a && ./scripts/feeds install -a 4.apply the patch  patch -p1 <minibox-v3_2 minibox-v3_2 5.make menuconfig & make kernelmenuconfig select the right target & compile